How to Connect a Sharp Projector to a Network
Quick Reference Guide
Applicable Models:
XG-V10WU XG-V10XU
XG-V10WM XG-V10XM
B.) Set IP Address
NOTE: IP Address is Static - verify with
IT / MIS Department.
Quick Reference Guide Sections:
1.) AN-L10T Installation
2.) Projector Configuration
3.) S.A.P.S. Configuration
1.) Install Lan Card into expansion slot
on A/V connector side of the projector
Refer to Operation Manual - page 5
C.) Set Gateway
Refer to O/M page numbers 2 - 3 for details
2.) Configure Projector Menu
There are (4) four items to configure
on the projector menu.
A.) Set ID Number
B.) Set IP Address
C.) Set Gateway
Must be
obtained from
IT / MIS
Refer to Operation Manual - page 6
D.) Set Subnet Mask
Department
A.) Set ID Number
D.) Set Subnet Mask
Refer to Operation Manual - page 7
Refer to Operation Manual - page 4
3:18 PM
10/12/2001
1
L:\tekcentr\cactrain\qck_ref.xls
|